X-Ray Directional Radiographic Inspection Machine Ceramic Tube Penetrant 50mm

320KV Ceramic tube penetrant 40mm Directional Radiographic inspection machine

Main technical parameters

Standard Delivery

System Installation

1.Check and count all goods to be received per the packing list. And then check the quality of the parts for damage,lost and mistake.

2.Keep the controller in a flat,dry and dustless place, switch off the power and connect the power cable.

(Note:

The power supply of the unit is single phase 220V±10% 50-60HZ)

3.If necessary,one end of earth wire can be connected to the earth terminal of the controller and the other end to the special grounding wire.

4.Connect controller to x-ray generator by special 9 cores cable,and form better contact.

5.Check the gas pressure gauge on x-ray generator and make sure it range from 0.35Mpa to 0.45Mpa.If not,the unit is not allowed to turn on so as to avoid any damage to the x-ray generator.

Working Principle

This machine is composed of intelligent controller-ray generator, power cable and connecting cable.

1.The controller will consist of the following sections:

Front Panel: LED display, status and failure indicator, touch keyboards (see the introduction of control panel)

Side Panel: power cable socket and connecting cable socket, power switch,key switch, fuse socket, warning lamp and wire connecting terminal of door-machine interlock.

Internal Circuit: power circuit, rectifying circuit, filter circuit, inverter circuit, control circuit and other circuited.

2.The x-ray generator will consist of the following sections:

X-ray tube, High voltage transformer, Temperature relay, Gas pressure gauge and Cooling fan etc.

3.The schematic diagram of the complete machine: